Automotive repair, skin light rail subway train, building decoration, hardware tools, solar gluing, electronic beat plastic, glass curtain wall, aquarium gluing, adhesives trade and other industries.
      Electric glue gun maintenance
gun leak: Remove the screws can be re-installed, then tighten the screw. Or plastic sealed glass look, a serious leak, contact the vendor to replace the gun body.
The front barrel leak: plastic is too long, leading to the front cover can not be tightened. Or its front cover is screwed into place.
gun back leak: seals damaged, or the rear muffler is damaged, contact suppliers invited to replace.
      Use of electric glue gun
1. With the glue gun to connect the compressed air pressure can not exceed 145 psi (10bar) 2. Glue gun before the demolition must not connect the compressed air. 3. To ensure a reliable glue gun to work, after use must be in accordance with the sealant manufacturers recommend removal of solvent the residual gum (Glue guns are not allowed to soak in a solvent) 4. If the air slowly escaping from the trigger valve, exhaust valve would be a clear failure, if there is such a case, should be replaced muffler exhaust valve diaphragm inside the film. 5. When used, the front cover must be tightened. 6. Suggested the use of all pneumatic tools wear goggles.