Pneumatic glue gun
1) The inlet leak: pump and plastic guns coherent and insufficient sealing port to connect an option for joint or pipe connected to a glue gun coherent population, with wire fixation.
2) gun leak: Remove the screws can be re-installed, then tighten the screw. Or plastic sealed glass look, a serious leak, contact the vendor to replace the gun body.
3) The front barrel leak: plastic is too long, leading to the front cover can not be tightened. Or its front cover is screwed into place.
4) gun back leak: seals damaged, or the rear muffler is damaged, contact suppliers invited to replace.
Electric glue gun
1) gun leak: Remove the screws can be re-installed, then tighten the screw. Or plastic sealed glass look, a serious leak, contact the vendor to replace the gun body.
2) The front barrel leak: plastic is too long, leading to the front cover can not be tightened. Or its front cover is screwed into place.
3) gun back leak: seals damaged, or the rear muffler is damaged, contact suppliers invited to replace.
4) not enough battery power, replace the battery.

Author: Jiande Tongyu Electrical Tools Factory
Website: www.tygluegun.com
Main Products: glue gun?glue stick